![]() I also tried to install the ST-LINK server manually with the. Does this mean that the ST-LINK server is also installed since IDE version 1.4? So how exactly can i check if the ST-LINK server is installed and runs properly? There is no choice given in the driver section about weather to install ST-LINK server or not like in the previous version of the IDE installer. I installed the STMCubeIDE with the installer executable from the ST website. I'm really glad for any suggestion on my issue. I have installed all the components in the default directories. Or is it possible that there is any problem with the path the CubeIDE is serching for the driver? But why does the Utility connect to the device without any problem then? ![]() The only thing that's different on the Windows machine where the IDE is not working ist that the Keil MDK is installed with its "own" USB driver instance. I'm sure the issue is with the PC-system side or the IDE installation and nothing with the board's hardware but I'm running out of ideas. The firmware of the ST-LINK is up to date, the firmware-updater of both, the CubeIDE and the Utility Software can connect to the device and setting it into update mode. Still the same result: The Board works well with the ST-LINK Utility software but it doesn't with the Cube IDE, nor after reinstallation. I have also tried to reinstall the drivers manually but without any success. I have checked the Windows device manager, too: The ST-LINK debug probe instantly appears when I plug in the cable and runs with the dedicated ST driver as required. With the ST-LINK Utility software I can connect the target device and flash binaries without any problem. I've already read the other tasks about this problem, so here comes what differs in my case: So the hardware and jumper setup is correct. When I run the same project with exact the same settings on another Windows 10 machine, everything works fine and the onboard debugger conntects without any problem. No ST-LINK detected! Please connect ST-LINK and restart the debug session. When I know try to run or debug a simple example project the ST-LINK firmware verification opens instantly with the message: I have first installed the latest version of the IDE on an Windows 10 machine with the ST-LINK USB drivers that are required. ![]() I try to connect a NUCLEO-F429ZI board with STM32CubeIDE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |